1992 chevy astro 2 WD, 4 wheel anti lock brakes. No fluid flow to rear brakes. Master cylinder changed and bench bled successfully. ABS is picking up fault code 32 (RR wheel sensor supposedly). Does the abs pump need to be reset? If so, how?
Thanks for any reply.
Andy.1992 chevrolet astro-no brake fluid to rear?
get avacum bleeder and bleed the living **** out of your bakes were taking a hole bottle see if there is dirt or another object in the system1992 chevrolet astro-no brake fluid to rear?
I don't know much about Chevy, but I know that when I get the brakes serviced on my BMW, they change out the brake sensors as well, or the onboard computer will keep faulting and showing that the brake pads are worn out. Could it be that you need to replace the sensors as well? Just a suggestion.1992 chevrolet astro-no brake fluid to rear?
proportioning valve is bad.1992 chevrolet astro-no brake fluid to rear?
Get it to a f***in' repair man!!!!1992 chevrolet astro-no brake fluid to rear?
Right rear wheel censor has nothing to do with brake fluid or master cylinders. It says your wheel sensor is not sending the required signal to the abs control. It could be a dirty connector a broken wire etc. NEVER replace ANY part till you know the problem. Your %26quot;mechanik%26quot; is gonna make a bundle changing parts and guessing what the problem is.1992 chevrolet astro-no brake fluid to rear?
when you bled the brakes did you start on caliper farthest away from the master cyl.? if your master cyl in on the drivers side start on the rear passenger side caliper and then do rear drivers side then front passenger side and then fron drivers side. if its on the passenger side start on the rear drivers side caliper then do the rear passenger side, front drivers side, front passenger side. also make sure to top off brake fluid after bleeding each caliper or you run the risk of bleeding air bubbles back in to the lines. hope this helps.1992 chevrolet astro-no brake fluid to rear?
yes you can try it and see if it comes on after time
